Dear All, Thank you!!!
I have too many boards that has the lpc2103. but problem is that,
out of 100 boards 52 boards
has the problem of programming failure. I am using ULINK2 20 wire
JTAG programmer for programming LPC2103. I am using voltage supply
from board which is 3.3 Volt. 48 boards programmed and tested. please
give me the suggestions.
My Check points:
1. Measured Vcc = 3.3 V DC.
2. Crystal Frequency: 12 Mhz
3. Pin no 27(DBGSEL) of LPC2103 is bounded to 3.3 volt by usi
↧