I am using a USB3300 board(http://www.kynix.com/uploadfiles/pdf9675/USB3300-EZK-TR.pdf)with
my Texas Instruments MCU (TM4C129), but there are things that I do
not understand, first, when I give to the USB3300 3.3V from a voltage
source, the CLKOUT pin generate a 60MHZ CLK signal, but the datasheet
says:
The reset input may be asserted when the USB3300 clkout signal is not
active (i.e. in the suspend state caused by asserting the SuspendM
bit) but reset must only be de-asserted when the
↧